Parts List & Step One

• Compressor with Oil
• Evaporator Unit with under-dash support bracket
• Drier
• Binary Switch
• Condenser
• Engine Mount kit with belt
• 10 Self -Tapping screws
• Two Grommets
• Two hose hold-downs
• Two 90 degree # 6 fittings
• One 45 degree # 6 fitting
• One straight # 6 fitting
• One 90 degree # 8 fitting w/ charging port
• One 90 degree # 8 fitting
• One 90 degree # 10 fitting w/ charging port
• One 90 degree # 10 fitting
• O-rings
• # 6, 8, 10 hose (Pre-made)
• Directions

Step One

1. Disconnect the Negative cable first and then Positive Battery Cable.
2. Remove the Ashtray from underneath the dashboard. Slide the ashtray out of the holder in order to remove all the screws.
3. Leave all the wires going to the ashtray connected if possible, or disconnect and reconnect after the installation.